Switching Off And Storing The Refrigerator - Dometic CR Serie Instrucciones De Montaje

CRD0050
➤ Set the temperature control knob (fig. 2 1 page 3) to "0".
➤ Leave the door open.
8.3 Undo the lock
A
NOTICE!
Only adjust the locking mechanism when the drawer is open. The unit
will be damaged if this is adjusted when the drawer is closed.
The refrigerator has a locking mechanism (fig. a 1, page 7) which is also used to
protect it during transport. The following settings are possible:
• Lock (turn wheel clockwise all the way): The drawer is locked and secured.
To open the drawer, lift the handle up and lift the drawer out.
• Vent (turn wheel anti-clockwise all the way): The drawer is slightly open, but
fixed in position.
Use this position if you are not going to use the unit for a long time.
8.4

Switching off and storing the refrigerator

If you do not intend to use the refrigerator for a long time, proceed as follows:
➤ Set the temperature control knob (fig. 2 1 page 3) to level "0".
The cooling unit is only switched off when you hear a click.
➤ Disconnect the power cable from the battery or pull the AC cable plug out of the
rectifier.
➤ Clean the refrigerator (see chapter "Cleaning and care" on page 22).
➤ Turn the locking wheel (fig. a 1, page 7) anti-clockwise to the end stop
("Vent").
➤ Close the door until it latches in.
✓ The door stays open thus preventing smells from arising.
EN
Using the refrigerator
21