Dometic CR Serie Instrucciones De Montaje página 15

CRD0050
Install the refrigerator so that the warm air produced can easily flow away (either
upwards or to the sides). Therefore make sure there is adequate ventilation (fig. 3,
page 4).
No. in
fig. 3, page 4
1
2
3
4
The condensation which forms during normal operation of the refrigerator can be
drained off via two outlets on the refrigerator. For delivery purposes, these outlets
are sealed. The two outlets are located on the rear and on the underside of the refrig-
erator (fig. 4, page 4).
➤ Choose the condensation outlet most suitable for the place of installation and
remove its cap.
➤ Insert a sharp object (e.g. a screwdriver) approx. 25 to 30 mm into the outlet to
pierce open the inside of the refrigerator.
➤ Remove the drip-tray (fig. 5 1, page 5).
➤ Connect a hose (fig. 6 2, page 5) to the outlet connections (fig. 6 1, page 5).
EN
Explanation
Cold intake air
Hot waste air
Condenser
Spacing above the refrigerator if insufficient air can circulate above
or at the side
Installing and connecting the refrigerator
15