Intended Use; Instructions Before Installation - Dometic MAGICWATCH MWE 6004 Instrucciones De Montaje

MWE6004
5

Intended use

Dometic MWE6004 (ref. no. 9101500081) is a parking aid based on ultrasound.
When manoeuvring, it monitors the space behind the vehicle and provides an
audible and visible warning signal for any obstacles it detects.
MWE6004 is designed for installation in commercial vehicles.
6

Instructions before installation

6.1 Painting the sensors
See fig. 2
I
NOTE
The sensors may be painted. The manufacturer recommends having the
sensors painted by a specialist workshop.
6.2 Determining the place of installation for the sensors
See fig. 3 to fig. 5
I
NOTE
The sensors must be correctly aligned for the device to work properly.
If they point to the ground, irregularities and bumps on the surface may
be interpreted as obstacles. If they point too far up, obstacles will not be
detected at all.
Note the following during installation:
•
The area around the sensors must be free from other objects.
•
The distance from the sensors to the ground should be at least 45 cm and a
maximum of 60 cm (fig. 3). The optimum height is 50 cm.
•
Note that the installation angle depends on the installation height.
Select the right sensor holder and the appropriate drill diameter by consulting
the table in fig. 3.
Supplementary to fig. 5
➤ Observe the intervals between sensors.
EN
Intended use
7