Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
USER'S MANUAL. PRODIG-5
5.3
Selecting the Operation Mode: TV / Spectrum Analyser /
Measurements
The PRODIG-5 (
Analyser and Measurements. To switch from TV operation mode to the Spectrum
Analyser press
[13] key. To switch to the Measurements mode press
In the TV operation mode the demodulated television signal is shown on-screen;
this is the default operation mode, various functions can be selected, as shown in the
following paragraphs.
In the Spectrum Analyser operation mode the screen displays the spectrum of
the active band (terrestrial or satellite). The span and the reference level.
In the Measurement mode the screen shows the available measurements
according to the type of signal selected.
5.4
Channel Tuning / Frequency Tuning
Pressing
[24] key the
tuning and back again.
In channel tuning mode turning the rotary selector [1] sequentially tunes the
channels defined in the active channels table. When turning it clockwise frequency
increases while turning it anticlockwise frequency decreases.
In frequency tuning mode there are two ways of tuning:
1. Turning the rotary selector [1].
Turning the rotary selector [1] selects the desired frequency (tuning is
continuous from 45 to 865 MHz and from 950 to 2150 MHz). When turning it
clockwise frequency increases while turning it anticlockwise frequency
decreases.
2. Using the keyboard.
Press the rotary selector [1] (the frequency listing will disappear and will
appear on the upper left corner of screen the keyboard symbol of manual data
entry
), next enter the frequency value in MHz using the numeric
keyboard. The
entered value and then display it on-screen.
11/2013
) has three basic operation modes: TV, Spectrum
EXPLORER
switches from frequency tuning to channel
EXPLORER
will calculate the tuneable frequency closest to the
EXPLORER
[12] key.
Page 29
Publicidad
Capítulos
Tabla de contenido
