Automatic Signal Identification Function (Auto Id) - Promax PRODIG-5 Manual Del Usuario

USER'S MANUAL. PRODIG-5
Band
SATELLITE
TERRESTRIAL
MATV
In the External power supply mode is the unit powering the amplifiers before the
antenna (terrestrial television) or the satellite TV receiver (house-hold or community)
also powers the external units.
The DRAIN [3] indicator lights when current is flowing to the external unit. If any
kind of problem occurs (e.g., a short circuit), an error message appears on the monitor
('SUPPLY SHORT'), the acoustic indicator will be heard and the instrument will cease
to supply power. The PRODIG-5
state until the problem has been solved, during this time it verifies every three seconds
the persistence of the problem warning with an acoustic signal.
5.8

Automatic signal identification function (AUTO ID)

The PRODIG-5 (
according to the established configuration, which are presents in the channel or tuned
frequency. In order to activate this function must once press
useful, is to combine this process with the spectrum monitoring
locating the marker on the levels susceptible to contain a transmission, and activating
later the process of automatic identification in order to identify the present signal.
11/2013
Powering voltages
External
13 V
15 V
18 V
24 V
13 V + 22 kHz
18 V + 22 kHz
External
13 V
15 V
18 V
24 V
Table 3.- External units powering voltages.
(EXPLORER)
) allows automatically identifying TV signals,
EXPLORER
5 V
5 V
does not return to its normal operating
[25] key. Specially
[13], so that after
Page 31