Acquisition Function (Datalogger) - Promax PRODIG-5 Manual Del Usuario

NOTE:
The symbol
equipment is saving information to the internal memory. This symbol
appears whenever the user selects a data storage option when pressing the
rotary selector [1].

5.10 Acquisition function (DATALOGGER)

The Datalogger function allows the user to carry out and store measurements in
a fully automatic way. It can store for each acquisition the measurements made in
different points of the installation. The measurements made are relevant to the current
analogue or digital channel, in the active channel plan.
To select the Datalogger function, activate the UTILITIES
select the RUN DATALOGGER option. Later, by turning the rotary selector [1] select a
previously stored acquisition or a NEW DATALOGGER.
DVB-T. MPEG-2. MEASURING...
In the case of digital channels, which require a greater calculation process, a
timer counter will appear in the lower part of the screen. In the upper corner the channel
number being measured will appear, followed by the total number of channels in the
current channel plan.
In order to select the different fields on the screen, press the cursor keys
[6] and then edit by pressing the rotary selector [1].
Page 34
in the upper corner of the screen indicates that the
14/41
TEST POINT:
CHANNEL SET:
FREC: 482.00 MHz
-1 kHz
CAN: 22
CANCEL
Figure 11.- DATALOGGER screen.
USER'S MANUAL. PRODIG-5
DATALOGGER_00
POINT_01
LEMSFORD
C/N: 7.5
POTEN.: 52.1 dBµV
MER: 6.4
CBER: 7.2E-2
VBER: 1.7E-3
21 Sec.
[22] menu and
dB
dB
11/2013