Datalogger For Attenuation And If Sat Test - Promax PRODIG-5 Manual Del Usuario

USER'S MANUAL. PRODIG-5
After selecting the START field the instrument begins to carry out the available
measurements automatically. Once completed, the process will be ready to repeat
again (for example, for a new test point), or view measured data by turning the rotary
selector [1], or store the information in memory (SAVE) or exit from this acquisition
(EXIT).
5.10.1 DATALOGGER for Attenuation and IF SAT tests
The PRODIG-5 allows to make measurement acquisitions while executing an
Attenuation test at terrestrial band or an IF SAT test at satellite band (see section
"5.11 Verification of distribution networks").
For it, one of these tests should be activated previously as the following figure
shows.
10
0
-10
-20
FREQ:
REF:
TEST:
ATT:
Figure 12.- Attenuation Test. Terrestrial band.
In order to make the automatic acquisition of these measurements, select it from
UTILITIES menu by
DATALOGGER option, and later the NEW DATALOGGER option. In the CHANNEL
SET field will appear the type of test that the instrument is going to store automatically.
11/2013
48.30 519.25
90.6 83.7
86.3 73.1
4.3 10.6
CALIBRATE
pressing the
631.25 MHz
83.6 dBuV
70.2 dBuV
13.4 dB
EXIT
[22] key, and activating the RUN
Page 35