Loudness; Audio Control; Audio Setup - Kenwood Ez900HDS Manual De Instrucciones

Loudness

Compensating for low and high tones during low
volume.
Press the [LOUD] knob for at least 1 second.
Each time the knob is pressed for at least 1
second the Loudness turns ON or OFF.
When it's ON, "LOUD ON" is displayed.

Audio Control

1
Select the source for adjustment
Press the [SRC] button.
2
Enter Audio Control mode
Press the [AUDIO] knob.
3
Select the Audio / Sub item for adjustment
For Audio item : Press the [AUDIO] knob.
Each time the knob is pressed the audio items
that can be adjusted switch as shown below.
For Sub item : Press the [FM] / [AM] button.
Each time the button is pressed the sub items
switches when audio item selected for Bass,
Middle and Treble level.
4
Adjust the Audio / Sub item
Turn the [4] / [¢] knob.
Audio Item [Sub Item] Display
Sub woofer level*¹ "SW Level"
Bass [level] "Bass"
[Center Frequency]*² "Bass F"
[Extend]*² "Bass EXT"
[Q Factor]*² "Bass Q"
Middle [level] "Middle"
[Center Frequency]*² "MID F"
[Q Factor]*² "Middle Q"
Treble [level] "Treble"
[Center Frequency]*² "TRE F"
Balance "Balance"
Fader "Fader"
• According to the Bass Q Factor setting value, the
frequencies that can be set in Bass Center Frequency
change as shown below.
Bass Q Factor Bass Center Frequency
1.00/1.25/1.50 60/70/80/100
2.00 60/70/80/150
5

Audio Setup

1
2
3
4
Range
–15 — +15
–8 — +8
60/70/80/100 or 150 Hz
ON/OFF
1.00/1.25/1.50/2.00
–8 — +8
0.5/1.0/1.5/2.0 kHz
1.0/2.0
–8 — +8
10.0/12.5/15.0/17.5 kHz
Left 15 — Right 15
Rear 15 — Front 15
5
• When the Bass Extend is set to ON, low frequency
response is extended by 20%.
• *¹ This mode is available only when <Subwoofer
Output> (page 14) is ON.
• *² This mode is available only when <System Q
Setting> (page 29) is ON.
Exit Audio Control mode
Press the [AUDIO] knob for at least 1 second.
Select the source for adjustment
Press the [SRC] button.
Enter Audio Setup mode
Press the [AUDIO] knob for at least 1 second.
Select the setup item for adjustment
Press the [AUDIO] knob.
Each time the knob is pressed the items that can
be adjusted switch as shown below.
Adjust the Audio Setup item
Turn the [4] / [¢] knob.
Setup Item Display
System Q*¹ "Flat/User/
Rock/Pops/
Easy/Top40/
Jazz"
Front High Pass Filter "HPF F"
Rear High Pass Filter "HPF R"
Sub woofer Low Pass "LPF SW"
Filter*²
Volume offset "V- Offset"
*¹
• System Q: You can recall the best sound setting
preset for different types of music.
- User memory: The values set on the <Audio
Control> (page 11).
- Each setting value is changed with the <Speaker
Setting> (page 12).
- First, select the speaker type with the Speaker
setting.
• *² This mode is available only when <Subwoofer
Output> (page 14) is ON.
• Volume offset: Each source's volume can be set as a
difference from the basic volume.
Exit Audio Setup mode
Press the [AUDIO] knob for at least 1 second.
Range [Sound setting]
[Flat/User memory/
Rock/Pops/
Easy/Top40/
Jazz]
Through/100/125/170 Hz
Through/200Hz
50/80/120/Through Hz
–8 — ±0
| 11
English