Removing The Unit - Kenwood Ez900HDS Manual De Instrucciones

Removing the Unit

Removing the hard rubber frame
1
Engage the catch pins on the removal tool and
remove the two locks on the upper level.
Upper the frame and pull it forward as shown in
the figure.
Accessory2
Removal tool
2
When the upper level is removed, remove the
lower two locations.
• The frame can be removed from the bottom side in the
same manner.
40
|
English
Lock
Catch
Removing the Unit
1
Refer to the section <Removing the hard rubber
frame> (page 40) and then remove the hard
rubber frame.
2
Remove the screw (M4 × 8) on the back panel.
3
Insert the two removal tools deeply into the slots
on each side, as shown.
Screw (M4X8)
(commercially available)
4
Lower the removal tool toward the bottom, and
pull out the unit halfway while pressing towards
the inside.
• Be careful to avoid injury from the catch pins on the
removal tool.
5
Pull the unit all the way out with your hands,
being careful not to drop it.
Accessory2
Removal tool