Safety Precautions; Disposing Of The Unit; Parts Names - Mitsubishi Electric Mr. Slim SEZ-M25DAL Manual De Instrucciones

1. Safety Precautions

• Only use means recommended by the manufacturer to accelerate
the defrosting process or to clean.
• This indoor unit shall be stored in a room that has no
continuously-operating ignition device such as open flame, gas
appliance, or electrical heater.
Caution:
• Do not use any sharp object to push the buttons, as this may
damage the remote controller.
• Never block or cover the indoor or outdoor unit's intakes or
outlets.

2. Parts Names

■ Indoor Unit
Fan steps
Vane
Louver
Filter
Filter cleaning indication
■ Wireless Remote-Controller
ON/OFF button
Pushing button starts operation.
Pushing again stops operation.
FAN SPEED button
This button is used to set fan
speed to low, medium or high.
MODE SELECT button
This button is used to change
between auto, cooling, heating
and drying operation modes.
CHECK button
TEST RUN button
SEZ-M·DAL
3 steps
–
–
Normal
–
CHECK
MODEL SELECT
NOT AVAILABLE
ON/OFF
MODE
CHECK
TEST RUN
SET
• Do not pierce a hole in or burn this indoor unit or refrigerant
lines.
• Be aware that the refrigerant may be odour-free.

Disposing of the unit

When you need to dispose of the unit, consult your dealer.
Air outlet
TEST RUN
TEMP
FAN AUTO STOP
VANE AUTO START
LOUVER h
min
RESET CLOCK
Air intake
Filter
SET TEMPERATURE button
SET TEMPERATURE button
sets and any desired room tem-
perature.
AUTO STOP/AUTO START button
Used for selecting timed starting
or stopping.
VANE CONTROL button
Used to change the airflow direc-
tion.
h button
Used for setting the current time.
min button
Used for setting the current time.
LOUVER button
Used for adjusting the airflow
direction.
3