Functional Description; Product Specifications; Unpacking - Delta 31-140 Manual De Instrucciones

The DELTA ® 12" Disc Sander is designed for sanding or polishing flat or beveled surfaces on wood and plastic
materials.
Speed:
Disc Diameter:
Table Tilt:
Height:
Width:
Shipping Weight:
Motor:
Table Size:
Dust Collection Outlet:
Miter Gauge Groove:
Length:
Weight:
The machine is heavy, be careful when removing it from the shipping container! Failure to comply
may cause serious injury and/or damage to the sander and/or property!
Your DELTA ® 12" Disc Sander comes packed in a single container. Use a safety strap to avoid tip-over when lifting
machine. Check shipping carton and machine for damage before unpacking.
Open the shipping container. Carefully remove packaging materials, parts and machine from shipping carton. Always
check for and remove protective shipping materials around motors and moving parts. Lay out all parts on a clean
work surface and check that all parts are present and in good condition:
• 12" disc sander (1)
• Dust collection hose with 2 ¼" port
adaptor (1)
• Brake lever assembly (1)
Compare the items to inventory figures; verify that all items are accounted for before discarding the shipping box.
Report any missing or damaged parts to your distributor or dealer. Prior to tool assembly and use, read this manual
thoroughly to familiarize yourself with proper assembly, maintenance and safety procedures.
Remove any protective materials and coatings from all of the parts and the disc sander. The protective coatings
can be removed by spraying WD-40 on them and wiping it off with a soft cloth. This may need redone several times
before all of the protective coatings are removed completely
If any parts are missing, do not attempt to plug in the power cord and turn "ON" the machine. The
machine should only be turned "ON" after all the parts have been obtained and installed correctly.

FUNCTIONAL dESCRIPTION

PROdUCT SPECIFICATIONS

UNPACkINg

dESCRIPTION (QUANTITY)
7
1725 RPM
12"
+45° to -45°
15"
17 ¼"
81 lbs
½ HP, 120 V, 1 Phase, 60 HZ
17 ¼" x 6 ¼"
2 ¼"
3/8" x 3/4"
17 ¾"
72 lbs
• Miter gauge
• 2.5mm Allen wrench (1)
• 4mm Allen wrench (1)