Troubleshooting; Disposal - Dometic COOLFREEZE CDF 11 Instrucciones De Uso

Troubleshooting

9 Troubleshooting
Fault
Device does not function,
"POWER" LED does not
glow.
The device does not cool
(plug is inserted, "POWER"
LED is lit).
The device does not cool
(plug is inserted, "POWER"
LED flashes, the display is
blank).
When operating from the
DC power socket:
The ignition is on and the
cooling device is not
working.
"ERROR" LED flashes and
the display shows "ERR1"
or "ERR2".
10

Disposal

➤ Place the packaging material in the appropriate recycling waste bins wherever
possible.
M
If you wish to finally dispose of the product, ask your local recycling centre
or specialist dealer for details about how to do this in accordance with the
applicable disposal regulations.
18
Possible cause
There is no voltage
flowing from the DC
power socket in your
vehicle.
Defective
compressor.
Battery voltage is too
low.
The fitting of the DC
power socket is dirty.
This results in a poor
electrical contact.
The fuse of the DC
plug has blown.
The vehicle fuse has
blown.
Device is defective.
CoolFreeze CDF11
Suggested remedy
There is no voltage flowing from the
DC power socket in your vehicle.
This can only be repaired by an
authorised repair centre.
Check the battery and charge if
necessary.
Check the wiring and connections.
If the plug becomes very warm in the
DC power socket fitting, either the fit-
ting must be cleaned or the plug has
not been assembled correctly.
Replace the fuse of the DC plug with
one of the same rating.
Replace the vehicle's DC power
socket fuse. Please refer to the operat-
ing manual of your vehicle.
This can only be repaired by an author-
ised repair centre.
EN