Bresser TemeoTrend Sunny Instrucciones De Uso página 14

USING TABLE STAND OR WALL
MOUNTING
The main unit has a removable table stand, which
- when connected - can support the unit on a flat
surface. It is possible to remove the stand and
mount the unit on a wall using the recessed screw
hole. The same applies to the remote unit; it can be
placed on a flat surface or mounted on a wall using
the recessed screw hole.
OPERATION
Receiving measurements and time signal
Once batteries are placed in the remote unit, it will
start transmitting temperature readings at roughly 45
second intervals. As soon as batteries are installed
in the main unit it will start searching for a signal
from the remote sensor for about 3 minutes. Upon
successful reception of the signal, the outdoor
temperature will be displayed on the main unit. The
main unit will automatically update its readings at
about 45 second intervals.
Subsequently, the main unit will attempt to receive
the DCF77 radio signal. The reception symbol
flashes. When the time signal is received after 3-5
minutes, the current time and date appear in the
display. The reception symbol will now be shown
permanently in the display. Date and time are
automatically updated daily at 2:05 o'clock (CET) by
the main unit.
Temperature and humidity
1. Press the DOWN button to switch the displayed
temperature between °C and °F.
14
2. Once the battery is installed, the main unit
will start displaying the interior measurement
information. The main unit will display the
information from the remote sensor for the first
time approximately 3 minutes after the power
supply was established.
3. There are 3 different icons to displaying the
indoor climate as below:
humidity is same or lower than 40%
humidity is same or higher than 70%
humidity is higher than 40% but lower than 70%;
at same time, the temperature is higher than 20°C
(68°F), but lower than 27°C (80.6°F)
Max/Min records of temperature and humidity
1. Pressing and releasing the UP button in short
intervals repeatedly makes the display alternate
between the current temperature and humidity
as well as MIN/MAX recordings.
2. In MIN/MAX temperature display mode, hold UP
button to reset all indoor and outdoor MIN/MAX
records to current values.
4. The MIN/MAX temperature and humidity values
will be recorded automatically.
3. The MIN/MAX temperature and humidity records
automatically will be reset at 0:00 o'clock (12:00
a.m.) every day.
Current weather and weather trend
The weather forecast is depending on the
fluctuation of temperature and humidity. From