Bresser TemeoTrend Sunny Instrucciones De Uso página 16

2. If the time signal receiving fails again, the time
can be set manually.
Manual time setting
1. Press and hold the SET button in normal display
mode for 2 seconds to enter into time setting
mode.
2. The figure to be set will start flashing.
3. Press DOWN or UP to change the value.
4. Press SET button to confirm and go to the next
value to be changed.
5. The setting order is year >> month >> date
>> language selection for display of the day
(abbreivaited) >> time zone >> 12/24hr >> hour
>> minute >> save and exit.
6. If there is no operation for 30 seconds, the
existing setting will be saved and the device
returns to normal display mode. Press SET
button again to confirm and exit setting.
Alarm setting
1. Press and hold the ALARM button in normal
display mode for 2 seconds to enter into alarm
time setting mode.
2. The figure to be set will start flashing.
3. Press the DOWN or UP button to change this
setting.
4. Press the ALARM button to confirm and go to
the next setting.
5. The setting order is hour >> minute >> save and
exit.
6. Press ALARM again to confirm and exit setting
mode.
7. Press SET button to turn on or off the alarm,
When the alarm is activated, the icon
16
showed on the screen. When this alarm bell
symbol is not displayed the alarm is off.
8. The alarm sounds for a total of 2 minutes and will
change characteristics along that time.
Snooze/light function
1. When alarm is ringing, you can press the
SNOOZE/LIGHT button to silence it for 5
minutes. The icon
2. Press any other button to turn off the alarm. The
alarm will activate again after 24 hours at the set
time.
3. During normal operation mode, a press of the
SNOOZE/LIGHT button turns on the backlight
for 20 seconds.
Temperature buzzer setting
1. Press and hold the DOWN button in normal
display mode for 2 seconds to enter into
temperature buzzer setting.
Note: Make sure that you have set the correct
channel for the desired sensor.
2. Press the DOWN or UP button to turn on or off
the temperature buzzer.
3. Press the SET button to confirm and go to next
setting.
4. The setting order is: temperature buzzer ON/
OFF >> highest temperature limit >> lowest
temperature limit. If the UP or DOWN button is
held and presses continuously, the value will
change faster.
Note: The range for maximum upper limit is 70°C
is and maximum limit for lower temperatures is -50°C.
will now flash as well.