Cleaning And Maintenance - Bresser TemeoTrend Sunny Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

5. Press SET button again to confirm and exit
setting.
Note: As long as the outside temperature has
exceeded or fallen below the set limits, the
alarm will sound every minute for a duration of 2
seconds. Furthermore the display for the outdoor
temperature and the symbols
flashing.
Sensor function
1. Press CH button to set the channels 1 to 3 for
each transmitter if you wish to connect more
than one transmitter with the main unit.
2. Press °C/°F to change the temperature display
of the transmitter
3. Once the weather station receives radio signals
from the sensors, the alternating temperature
values of the different channels will be updated
on the weather station every 1-2 minutes.
TROUBLESHOOTING
Signal disconnection
If without obvious reasons the display of the
outdoor temperature goes blank, please check the
following:
1. The remote unit is still in place.
2. The batteries of both the remote unit and main
unit are not empty. Replace batteries with new
ones if necessary.
Note: When the temperature falls below freezing
point, the batteries of outdoor units will freeze,
lowering their voltage supply, effective range, and
life span.
3. All units required are within range and the path is
clear of obstacles and interference. Shorten the
distance if necessary.
Transmission collision
Signals from other household devices, such
as door bells, home security systems and
or
are
entry controls, may interfere with those of this
product and cause temporarily reception failure.
This is normal and does not affect the general
performance of the product. The transmission
and reception of temperature readings will resume
once the interference recedes.
SPECIFICATIONS
Measurement
Indoor temperature range: 0~50° C
Outdoor Temperature Range: -20~60° C
Resolution for temperature: 0.1° C
Humidity range: 20~90%
Resolution for humidity: 1%
Transmission
Transmission range between transmitter and main
unit: 30meters (in open area)
Radio frequency: 433.92 MHz
Power supply
Main unit:
Remote sensor:

CLEANING AND MAINTENANCE

Before cleaning the device, disconnect it from the
power supply (remove batteries)!
Only use a dry cloth to clean the exterior of the
3x AAA 1.5V battery
2x AAA 1.5V battery
DE
GB
FR
IT
ES
17

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

70-00001

Tabla de contenido