Adjusting The Speaker Volume - Sharp LL-T15S1 Manual De Funcionamiento

MENU 4: MODE SELECT
M O D E
[ O D S
O SD
4 0 0
S CAL I NG
1 0 2 4
V : 6 0
Notes:
- Depending on the resolution of the input signal, even
if menu options can be selected, the display may not
change.
- To choose a menu option:
- When adjustment complete: MENU button
OSD H-POSITION (OSD horizontal position)
The position of the OSD display can be moved to the left
and right. (
OSD V-POSITION (OSD vertical position)
The position of the OSD display can be moved up and
down. ( buttons)
400 LINES (degree of resolution)
You can specify the horizontal resolution of a 400-line
screen when using US text, etc.
( buttons)
640 640 X 400 dot mode
720 720 X 400 dot mode (US text etc.)
Note:
- As the resolution input for other than 400 lines is
done automatically, there is no need to set it.
SCALING (Level of scaling)
The sharpness of the image can be adjusted.
( buttons)
Note:
- When the display mode is set to less than
1024 x 768 pixels, the display is enlarged to cover
the whole screen (i.e. the side ratio of the display
may change).
- Display modes of 1024 X 768 pixels cannot be
changed.
Downloaded from: http://www.usersmanualguide.com/
Adjusting the screen display and speaker volume
S E L E C T
H - P O S I T I O N
V - P O S I T I O N
L I E N S 6 4 0 7 2
L V E EL 1 L VEL 2
E
x 7 6 8
H z H : 4 8 H z k
SELECT button
buttons)

Adjusting the speaker volume

Without the OSD menu and backlight adjustment bar
]
being displayed, press the
0 volume.
19
buttons to adjust the