Switching The Remote Control Id - Yamaha RX-497 Manual De Instrucciones

ADVANCED SETUP
3
Press the preset station number buttons (1
and 2) on the front panel repeatedly to move
through the menu and select the parameter
you want to adjust.
See page 29 for a complete list of available
parameters.
4
Press A/B/C/D/E on the front panel
repeatedly to toggle between the available
parameters.
5
Press MASTER ON/OFF to release it outward
to the OFF position to confirm your setting.
ON
Note
The settings you made are reflected next time you turn on the
power of this unit.
30
1 2
A/B/C/D/E
MASTER
OFF

Switching the remote control ID

You can select the unit you want to operate with the
remote control by switching the remote control ID.
1
Press and hold CODE SET on the remote
control and then press TUNER on the remote
control.
CODE SET
MENU
2
While holding down CODE SET on the
remote control, use the numeric buttons on
the remote control to enter the three-digit
code number listed in the table below.
CODE SET
MENU
Remote
control ID*
(this unit's
setting)
To operate this
ID1
alternative code.
To operate this
ID2
unit using the
(default setting)
* When you change the remote control ID, you must switch
the remote control ID of this unit (see page 29).
When using multiple YAMAHA receivers or
amplifiers with the same default code setting, you
may unwantedly operate those components
simultaneously. In this case, set one of the alternative
codes for this unit to operate this unit separately.
POWER POWER STANDBY POWER
TV AV
CD MD/TAPE TUNER
DVD DTV/CBL VCR PHONO
1 2 3 4
5 6 7 8
9 0 10 ENT.
TITLE MENU
BAND
ENTER
A/B/C/D/E A/B/C/D/E
RETURN DISPLAY
PRESET/CH
Function Code number
unit using an
801
802
default code.