Use Of Subassemblies/Modules In A Zone 2 Hazardous Area - Siemens SIMATIC S7-300 Manual De Producto

Use of subassemblies/modules in a Zone 2 Hazardous
Area
Approved devices/modules
Below you will find important information on the installation of the
subassemblies/modules in a hazardous area.
You can find the list of approved devices/modules on the Internet:
http://support.automation.siemens.com/WW/view/en/
Enter the associated article ID in the search window on this website, see table.
Production Location / Certification
II 3 G
Test number: see table below
Production Location
Siemens AG, Bereich A&D
Werner-von-Siemens-
Straße 50
92224 Amberg
Germany
Siemens AG, Bereich A&D
Östliche Rheinbrücken-
straße 50
76187 Karlsruhe
Germany
Note
Subassemblies/modules with
used in SIMATIC systems rated as category 3 equipment.
Product Information on the Use of subassemblies/modules in a Zone 2 Hazardous Area
A5E00352937-03
English
EEx nA II T3 .. T6
Subassemblies/Modules
ET-200S
ET 200S fault-tolerant
modules
S7-300
ET-200M
DP/PA bus interface
Diagnostics repeater
S7-300 fault-tolerant
modules
PROFIBUS Bus Connector
Plug
S7-400
S7-300 CP
TS Adapter II
TS Adapter IE
SIMATIC NET
ET 200M Marshalled
Termination Assemblies
II 3 G EEx nA II T3 .. T6 certification can only be
to EN 60079-15 : 2003
Test Number
KEMA 01
ATEX 1238X
KEMA 02
ATEX 1096X
KEMA 04
ATEX 1151X
KEMA 03
ATEX 1125X
KEMA 03
ATEX 1228X
KEMA 03
ATEX 1226X
KEMA 05
ATEX 1137X
Article ID
24037700
24038475
24028800
21479867
21497622
21089482
24193554
5