Makita RBC2500 Manual De Instrucciones página 6

Never straighten or weld damaged cutting tools.
– Operate the Brush cutter/String trimmer with as little noise and contamination
as possible. In particular check the correct setting of the carburetor.
– Clean the Brush cutter/String trimmer at regular intervals and check that all
screws and nuts are well tightened.
– Never service or store the Brush cutter/String trimmer in the vicinity of naked
flames.
– Always store the Brush cutter/String trimmer in locked rooms and with an
emptied fuel tank.
Observe the relevant accident prevention instructions issued by the relevant
trade associations and by the insurance companies.
Do not perform any modifications on the Brush cutter/String trimmer as this will
endanger your safety.
The performance of maintenance or repair work by the user is limited to those
activities as described in the instruction manual. All other work is to be done
by an Authorized Service Agent. Use only genuine spare parts and
accessories released and supplied by MAKITA.
Use of non-approved accessories and tools means increased risk of
accidents.
MAKITA will not accept any liability for accidents or damage caused by the
use of non-approved cutting tools and fixing devices of cutting tools, or
accessories.
First Aid
In case of accident make sure that a first-aid box is available in the vicinity of
the cutting operations. Immediately replace any item taken from the first aid
box.
When asking for help, please give the following information:
– Place of accident
– What happened
– Number of injured persons
– Kind of injuries
– Your name
Packaging
The MAKITA Brush cutter/String trimmer will be delivered in two protective
cardboard boxes to prevent transport damage. Cardboard is a basic raw
material and is therefore consequently reusable or suitable for recycling
(waste paper recycling).
Model; RBC2500, RBC2510
We declare under our sole responsibility that this product is in compliance with the following standards of standardized documents,
ISO11806, EN55012 in accordance with Council Directives, 89/392/EEC, amended 98/37/EEC, 93/68/EEC, 89/336/EEC, amended 92/31/
EEC.
Measured Sound Power: 110 dB
Guarantee Sound Power: 114 dB
These sound power levels wear measured in accordance with Council Directive, 2000/14/EC.
Conformity assessment procedure: Annex V.
Responsible Manufacturer:
Makita Corporation.
3-11-8,Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton kyenes, Bucks MK15 8JD, ENGLAND
EC-DECLARATION OF CONFORMITY
CE2007
Tomoyasu Kato
Director
5