Initial Setting - Mitsubishi Electric PAR-SL100A-E Manual De Instrucciones

3. Before Operation
F
7
9
A
Fig. 3-1
C
B
Fig. 3-2

3.2. Initial setting

The following settings can be made in the initial setting mode.
Temperature unit ºC/ºF
Time display
AUTO mode
Pair No.
Backlight
1) Switching to the initial setting mode
1
1. Press the
• If the weekly timer is enabled, press the
9 to disable the timer. (
2. Press the
4
• The Function setting screen will be displayed and the
2
function No. A will blink. (Fig. 3-1)
3
• Press the
3. Check that function No. "1" is displayed, and then press
the
6
5
• The display setting screen will be displayed. (Fig. 3-2)
2) Changing the temperature unit A (Fig. 3-2)
8
Press the
• Each time the
switches between
: The temperature is displayed in degrees Celsius.
: The temperature is displayed in degrees Fahrenheit.
3) Changing the time display B (Fig. 3-2)
Press the
• Each time the
switches between
4) Changing the AUTO mode C (Fig. 3-2)
Press the
• Each time the
switches between
mode.
A
5) Changing the pair No. D (Fig. 3-2)
D
Press the
• Each time the
changes.
E
6) Changing the backlight setting E (Fig. 3-2)
Press the
• Each time the
switches between
is pressed.
7) Completing the settings
Press the
• The function No. A blinks. (Fig. 3-1)
Press the
• The remote controller exits the initial setting mode.
(The air conditioner operation is stopped.)
Item Setting
12-hour format/24-hour format
Single set point/Dual set point
0–3
On/Off
button 1 to stop the air conditioner.
button 2.
button 4 to change the function No.
button 3.
button 5.
button 5 is pressed, the setting
and .
button 6.
button 6 is pressed, the setting
and
: The time is displayed in the 12-hour format.
: The time is displayed in the 24-hour format.
button 7.
button 7 is pressed, the setting
and .
: The AUTO mode operates as the usual automatic
: The AUTO mode operates using dual set points.
button 4.
button 4 is pressed, the pair No. 0–3
button 8.
button 8 is pressed, the setting
and
: The backlight comes on when a button is pressed.
: The backlight does not come on when a button
button 3.
button 2.
Fig. 3-1, 3-2
A
B
C
D
E
button
F disappears.)
.
.
7