Nedo SIRIUS 1 HV green Manual De Instrucciones página 14

Structure
Control panel of the IR remote control
The button symbols and functions correspond to the
comparable buttons on the control panel of the SIRIUS 1 HV
green, see page 13.
Exception:
13 Briefly lights up when buttons 4, 5 or 12 are pressed.
Flashes as long as buttons 1, 2, 3 or 6 are pressed.
Control panel receiver
1
Switches the receiver on and off.
"Acoustic signal" button
2
Switches the acoustic signal quied/loud .
"Detector field sensitivity" button
3
Switches the sensitivity between coarse/fine .
LCD display "Acoustic signal"
4
Lights up corresponding to "acoustic signal quied/loud".
5 Lights up if the laser line is located precisely at the level of
the zero line. In addition, a continuous tone is emitted.
6
"Coarse sensitivity" LCD display
7
Lights up if the sensitivity is set to "coarse".
"Fine sensitivity" LCD display
8
Lights up if the sensitivity is set to "fine".
9 Lights up if the laser line is within the sensor window but
below the zero line. A slow, intermittent tone is also emitted.
10 Lights up if the laser line is within the sensor window but
above the zero line. A rapid, intermittent tone is emitted.
11
Indicates the battery's state of charge.
Operating instructions Rotationslaser SIRIUS 1 HV green
"Send" LED display
"ON/OFF" button
LCD display "Target"
Detector field
LCD display "Lower"
LCD Display "Higher"
LED display "Battery"
13
8
7
9
10
11
2
1
EN
6
5
4
3
14