Initial Start-Up - Nedo SIRIUS 1 HV green Manual De Instrucciones

Initial Startup
SIRIUS 1 HV green
When starting the SIRIUS 1 HV green rotating laser up for the first time, charge the integrated
set of rechargeable batteries (4.8 V) using the charger supplied. The charger socket is located
below the handle, behind a rubber cap. While charging, the LED lights up red on the charger,
when a fault occurs, the LED flashes red. The set of batteries is fully charged when the green
LED on the charger lights up.
Important!
Only use the charger supplied.
IR remote control
Insert the 2 batteries supplied (type AAA) in the IR remote control.
Ensure pole direction is correct!
Receiver
Insert the supplied batteries into the receiver.
Ensure pole direction is correct!
Starting up the unit
When using on site, set up the SIRIUS 1 HV green according to the application.
Self-levelling
The SIRIUS 1 HV green has a self-
levelling feature.
This self-levelling feature is switched on
by pressing the ON/OFF button. The
horizontal beam (H) starts to rotate and
the plumb beams (L
on.
If the unit is placed in a slanted position of
up to 5° in any direction, the laser beams
are plumb and horizontal.
If the 5° range is exceeded, the horizontal
beam stops rotating and starts to flash
together with the two plumb beams (L
and L ).
2
Operating instructions Rotationslaser SIRIUS 1 HV green
and L ) are switched
1 2
1
EN
15