Electric Connection; Operation Of The Juicer - Profi Cook PC-AE 1001 Instrucciones De Servicio

Автоматическая соковыжималка PROFI COOK PC-AE 1001
Купить в интернет-магазине http://clatronic-shop.com.ua
6. Check the centrifugal sieve! Feel under the
sieve edge. It should not loosen under slight
tension.
7. Attach the transparent cover. It reaches all the
way over the pulp container.

NOTE
Your appliance is equipped with a safety
switch (4). It prevents accidental motor start.
Check the correct attachment of all compo-
nents, centrifugal sieve and transparent cover.
8. Lock the safety bracket over the transparent
cover.
9. Place the juice jug to the right of the appliance.
10. E nsure that the control knob is set to "OFF"
position.

Electric Connection

• Before inserting the power plug into the outlet,
check that the mains voltage to be used match-
es that of the device. You can find the required
information on the nameplate.
• Connect the device only to a correctly installed
safety socket for 220 – 240 V~ 50 Hz.

Operation of the Juicer

Display
Your automatic juicer is
equipped with a display
to read out the switch
settings. It is best visible
if you look at it horizon-
tally.
Switch Settings
• Press the "P" button for the motor to start im-
mediately with the highest speed.
• Turn the control knob from "OFF" to "ON" for the
motor to start at level 1.
• Operation is in addition displayed with an icon.
• Use the control knob to select one of 9 levels.
36
Which level to select for which fruit?
Please see the following overview to answer this
question.
1 - 2 Tomatoes, Melons
2 - 4 Plums, Pears (soft), Peaches, Man-
goes (peeled), Kiwis (peeled)
4 - 6 Oranges (peeled)
6 - 8 Cucumber
9 Pineapple (peeled), Pears (hard), Car-
rots, Celery, Apples
• Wash the fruit to be processed.
• Cut the fruit in pieces to fit through the filler
opening.
• Remove larger pips and stems.
Extracting Juice

NOTE:
The appliance is intended for short-term use.
Allow a pause of 3 minutes after 1 minute of
operation.
WARNING!
Check all accessories again for proper attach-
ment before switching the appliance on.
1. Set the switch to the desired position. The motor
starts running.
2. Insert the fruit pieces in the filler opening and
push them down with the tamper. Please note!
The tamper has a guideway in the filler opening.
3. The juice flows out at the right side of the cas-
ing. The pulp is collected in the pulp container.

NOTE:
• Observe the juice jug. Stop operation in time
to prevent overflowing.
• Small fruit, such as berries, are difficult to
process with the centrifugal method. Use the
berry press instead.
Stop Operation And Disassembly
1. Set the control knob to "OFF" position and wait
until the centrifugal sieve has come to a com-
plete standstill.