STERWINS 40VBC2-33.1 Instrucciones De Montaje página 326

4.1 UNBOXING
FR
ES
PT
3
IT
EL
9
PL
RU
KZ
UA
• Wear gloves when unboxing and assemble .
• Do not use cutter, knife, saw or any other similar tool for unboxing.
RO
• Carry the tool only by the handle (5).
• Keep the box for further reuse (transport and storage).
BR
• Keep instruction manual in a dry area for further consultation.
EN
4.2 INSTALLATION
Installing/Removing the battery pack : illustration 3.2 and 5.1
WARNING : Make sure the latch on the bottom of the battery pack snaps in place and the battery pack is
fully seated and secure in the product's battery docking port before beginning operation.
Failure to securely seat the battery pack could cause the battery pack to fall out, resulting in serious
personal injury.
To install : To attach, align and slide the battery pack onto the slots of the battery docking port until it
locks in place.
To remove : To release, press the battery unlock button and remove the battery pack from the product.
Assemble the shaft : illustration 2.1 and 2.2
Join the two shafts and install the bolt by a hexagon wrench. Do not overtighten. Ensure the shaft
coupler is fi xed securely.
Assemble the handle : illustration 2.3 to 2.7
1. Loosen the hand bolt on the side without hand shank.
2. Loosely clamp the lower handle on the upper stem.
1
2
4
5
7
8
10
NOTE : There are three position notches on the stem, choose
the best comfortable position when holding the tool.
1. Battery pack (not supplied)
2. ON/OFF trigger switch
3. Safety lock-off button
4. Harness
5. Handle
6
6. Shaft coupler
7. Trimmer head shield
8. Cutting head shield
9. Blade
10. Trimmer head
11. Trimmings spool
11
326