STERWINS 40VBC2-33.1 Instrucciones De Montaje página 329

• Before switching the product on, check whether it has been assembled correctly and all
the moving parts are running smoothly.
• We recommend slightly dampening surfaces in dusty conditions or using a mister
attachment.
• Operate the product only at reasonable hours – not early in the morning or late at night
when people might be disturbed.
• Avoid using the product in bad weather conditions, especially when there is a risk of
lightning. Do not operate the product in poor lighting. The operator requires a clear view
of the work area to identify potential hazards.
• Take care against injury from any device fi tted for trimming the fi lament line length,
if applicable. After extending new cutter line always return the product to its normal
operating position before switching on.
• Never fi t metal cutting elements.
• Never replace non-metallic cutting means with metallic cutting means
• Use of hearing protection reduces the ability to hear warnings (shouts or alarms).
The operator must pay extra attention to what is going on in the work area. Do not get
distracted, and always concentrate on the task.
• Operating similar tools nearby increases both the risk of hearing injury and the
potential for other persons to enter your work area.
• Keep fi rm footing and balance.
• Do not overreach. Overreaching can result in loss of balance. Always be sure of the
footing on slopes.
• Walk, never run. Keep all parts of your body away from any moving part.
• Never run the product without the proper equipment attached.
• Do not modify the product in any way or use parts and accessories that are not
recommended by the manufacturer.
If the product is dropped, suff ers heavy impact or begins to
vibrate abnormally, immediately stop the product and
inspect for damage or identify the cause of the vibration. Any
damage should be properly repaired or replace by an
authorized service centre.
• To reduce the risk of injury associated with contacting rotating parts, always stop the
machine, remove the battery pack, and make sure all moving parts have stopped:
- before cleaning or clearing a blockage
- when leaving the product unattended
- before installing or removing attachments
329
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
BR
EN