Franke CLOUD 1106 Manual De Uso página 10

4. CONTROLS
A
Button Function
Press repeatedly to change from level 2700K->3000K->4000K->5000K-
A
>6500K -> back to 2700K and so on.
Press the button to turn the lights on at full intensity.
Press the button again to reduce the lights to ½ intensity.
Press again to turn the lights off.
B
Press and hold the button for approximately 2" to activate automatic light
intensity control. The light intensity changes according to the light in the
room. It is deactivated by pressing button B for a further 2"
Turns the Motor on at speed 1.
C
Press with the motor on to turn the motor and all the buttons off.
odour sensor performs calibration.
N.B. the hood is pre-set for gas hobs, and calibration of the sensor
lasts 1'. DO NOT TURN THE MOTOR ON DURING CALIBRATION.
In this state the speed buttons have no effect, but the speeds of the motor
are regulated automatically.
D
It is deactivated by pressing button D
Press and hold the button for approximately 2" to change the type of hob,
from gas (default setting) to electric.
Press and hold the button again for 2" to change from electric hob to gas hob.
N.B. for an electric hob the calibration lasts approximately 15'.
DO NOT TURN THE MOTOR ON DURING CALIBRATION.
Turns the Motor on at speed 1.
Touch and hold the button for 2" to activate the 24h function.
E
This function carries out a 24h cycle and turns the motor on for 10' every hour.
Touch and hold the button for 2" to deactivate the function.
F Turns the Motor on at speed 2.
Turns the Motor on at speed 3.
Press and hold the button for approximately 2" to activate intensive speed,
lasting 6'.
G
At the end of the 6' the motor returns to the speed set previously.
If it is activated when the motor is off, the motor will switch off again after 6'.
It is deactivated by setting another speed, by pressing button C to turn the
motor off or by pressing and holding the button for a further 2".
Activates/deactivates the Delay function, which turns the motor and lights
off after 30'. This mode does not function if Intensive or 24h is active.
Press and hold the button for approximately 2" with the motor turned off,
H
operation of the hood.
continuous operation of the hood.
5. LIGHTING
• For replacement contact technical
support ("To purchase contact technical
support").
10
B C D E F G
Led
-
Led B remains off.
Led B lights up.
Button E lights up.
This situation is shown by the fact that Led D
Led D lights up at full strength.
Led D
The button light changes to full strength.
The button light changes to full strength.
The button light changes to full strength.
When the function is active the button light
changes to full strength.
With the motor turned off, Leds E and F
With the motor turned off, Leds G and H
H