Personal Protective Equipment; Before Use; Use Of Extension Cords - Hilti AG 230-S Manual De Instrucciones

equipment such as breathing protection, protective gloves, special overalls and safe-
ty helmet should be worn as necessary. When assessing whether breathing protec-
tion or a full face mask (respirator) should be worn, the hazardous characteristics of
the material to be cut or ground as well as any coatings applied to it should be taken
into account. In cases of doubt, full protective equipment should be worn. Use an
industrial vacuum cleaner, with an officially approved protection classification, which
complies with the local dust control regulations.
5.5 Requirements to be met by users
● The tool is intended for professional use.
● The tool may be operated, serviced and repaired only by authorized, trained per-
sonnel. This personnel must be informed of any special hazards that may be encoun-
tered.
● Always concentrate on the job you are doing. Proceed carefully and do not use the
tool if your full attention is not on the job.

5.6 Personal protective equipment

The operator and any other persons in the vicinity must wear suitable eye protection,
a safety helmet, ear protection, protective gloves and breathing protection (if no dust
extraction system is used) while the tool is in use.
Safety
helmet must
be worn
5.7 Protective equipment
Never use the tool without the disc guard fitted.

6. Before use

6.1 Use of extension cords

Use only extension cords of a type approved for the intended use and of adequate
cross section.
Recommended minimum cross sections and maximum cord lengths:
Supply
voltage
100 V
110–120 V
220–240 V
Do not use extension cords with 1.25 mm
Printed: 07.07.2013 | Doc-Nr: PUB / 5069436 / 000 / 00
Eye protection Respiratory
must be worn equipment
must be worn
■ The disc may become hot during use.
■ You may burn your hands.
■ Wear protective gloves when changing insert tools.
Conductor cross section
1.5 mm 2 2.0 mm 2 2.5 mm 2 3.3 mm
– 30 m – 50 m
20 m 30 m 40 m 50 m
50 m – 100 m –
2 or 16 AWG conductor cross sections.
Ear protection
must be worn
-CAUTION-
2 AWG AWG
– –
75 ft 125 ft
– –
Safety
gloves must
be worn
19