Description; Tools And Accessories - Hilti AG 230-S Manual De Instrucciones

Obligation signs
Safety
helmet must
be worn
These numbers refer to the corresponding illustrations. The illustrations can be
found on the fold-out cover pages. Keep these pages open while studying the oper-
ating instructions.
In these operating instructions, the AG 230-S diamond cutter is referred to as "the
tool".
Location of identification data on the tool
The type designation and serial number can be found on the rating plate on the tool.
Make a note of this data in your operating instructions and always refer to it when
making an enquiry to your Hilti representative or service department.
Type:
Serial no.:

2. Description

2.1 Electronic regulation and control
2.1.1 Starting current regulator
(only 230V version)
The current drawn by the tool at the moment it is switched on is many times that of
its rated current input. The starting current regulator (resistor) reduces this starting
current greatly, thus preventing the electric power supply fuse from tripping. It also
ensure that the tool starts smoothly, without a jolt.
3. Insert tools and accessories
Hilti abrasive cutting and grinding discs
(Max. dia. 230 mm, max. speed 6,500 r.p.m., max. disc peripheral speed 80 m/sec.)
AC-D universal premium
AC-D universal super premium
AC-D INOX
AG-D universal premium
AG-D universal super premium
AF-D abrasive flap disc
Products supplied by other manufacturers
(Max. speed 6,500 r.p.m.)
Wire brushes (max. dia. 100 mm, max. disc peripheral speed 45 m/sec.)
Cup wheels, rubber backing pads (max. dia. 230 mm, max. disc peripheral speed
80 m/sec.)
14
Printed: 07.07.2013 | Doc-Nr: PUB / 5069436 / 000 / 00
Eye protection Respiratory
must be worn equipment
must be worn
Ear protection
must be worn
Cutting
Cutting
Cutting
Grinding
Grinding
Grinding
Safety
gloves must
be worn