Compatible Systems; Downloading Videos; Reformatting The Micro Sd Card - Midland XTC 270 Manual De Instrucciones

Compatible Systems

The XTC-270 can be used on both Windows operating system and MAC.
The video codec is H.264, the file format is .MP4.

Downloading Videos

There is no need to install any software with the XTC-270. It is a plug and play device.
1. Before downloading videos, ensure batteries are fully charged.
2. Connect the camera to the USB port using the included cable.
3. Turn on the camera by sliding the "Record" switch in ON position.
4. The camera will be automatically recognized as an external hard drive (USB key) but videos could only be download; it is not
possible upload any data on your SD card based on current EU law.
5. All your videos will be saved into the "DC IM" > "100Media".

Reformatting the Micro SD card

Note: Format the micro SD card from the camera before the first usage.
The Micro SD card can be reformatted while in the camera. This allows you to delete all the videos at one time. Follow these steps:
1. Turn OFF the camera, sliding the RECORD switch to the OFF position.
2. Press and HOLD the Micro SD card reformat button.
3. Move the RECORD switch to the record position holding the reformatting button.
4. Release the reformatting button when the memory card LED is blinking green.
5. Turn OFF the camera, sliding the RECORD switch to the OFF position.
6. You will hear two beeps if the formatting process is successful.
7. Take out the Micro SD Card and use other device to format the card before using it again in the camera (Note: XTC270 cannot
delete the upgrade software)
Note: The camera cannot reformat the Micro SD card if the low battery light is on. Ensure new batteries are installed in the camera
before attempting the reformat process.
Note: XTC-270 is designed to be your ideal partner during all your adventures, so the CPU is totally turned OFF when the record
button is in OFF position to maximize the battery last. Due to this IT IS NOT POSSIBLE to set time and data.
16