STERWINS 40VPS2-24.1 Instrucciones De Montaje página 352

• Exercise caution when sawing both branches under tension or branches that are
FR
splintering.
ES
• Make sure to safe guard against the risk of injury from falling branches and fl ying wood
projectiles.
PT
• If the machine is in operation, keep persons and animals away from the danger area.
• When working on an incline, always stand above or to the side of the branch being
IT
sawed. Hold the machine as close as possible to your body. By doing so, you maximize
your balance.
EL
PL
RU
KZ
• To reduce the risk of injury associated with contacting rotating parts, always stop the
machine, remove the battery pack, and make sure all moving parts have stopped:
UA
- before cleaning or clearing a blockage
- when leaving the product unattended
- before installing or removing attachments
RO
- before checking, maintaining or working on the product
BR
Basic operating/cutting procedure : illustration 4.1 to 4.4
1. When removing branches, hold the pole saw at an angle ranging from 0 to 60° in order to avoid being
struck by a falling branch. The saw should never be operated directly above head.
EN
2. Saw off the lower branches on the tree fi rst. By doing so, it is easier for the cut branches to fall to the
ground.
3. At the end of the cut, the weight of the saw suddenly increases for the user since it is no longer being
supported by a branch. There is a risk of losing control of the saw, so make sure to stay alert during the
entire sawing operation.
4. Only pull the saw out of a cut while the saw is running. By doing so, you prevent the chain from
jamming in the wood.
5. Do not saw with the tip of the guide bar. Do not saw into the branch formations (where the tree
branches outwards). This will impede the tree's ability to heal.
6. For sawing off smaller branches, place the stop face of the saw on the branch. This prevents unwanted
movements of the saw at the beginning of the cut. While applying light pressure, guide the saw through
the branch from top to bottom.
7. For sawing off larger branches, fi rst make a relief cut. Saw through 1/3 of the branch diameter from the
bottom to top using the top side of the guide bar. Then saw from top to bottom for the other 2/3 using
the bottom side of the guide bar. Saw off longer branches in sections in order to maintain control over
the location of impact.
If the product is dropped, suff ers heavy impact or begins to
vibrate abnormally, immediately stop the product and
inspect for damage or identify the cause of the vibration. Any
damage should be properly repaired or replace by an
authorized service centre.
NOTE : The chain must be running at full speed before it comes
into contact with the wood.
352