Tabla de contenido
Publicidad
GB
Smøring
Fig. A + E
D
•
Borehammerens borepatron skal smøres regelmæssigt.
•
Smøremiddelstanden i maskinen skal regelmæssigt kontrolleres:
•
Fjern smøredækslet (fig A og fig E - nr. 6) oven på maskinen ved at dreje i retning af
NL
OFF, brug i givet fald en spids tang.
•
Fjern også det inderste dæksel.
•
De roterende dele inde i maskinen er nu synlige. Disse dele skal dækkes med fedtstof.
F
•
Kom om nødvendigt lidt fedtstof i smøreåbningen.
•
Sæt dækslet på igen, og drej det fast.
•
Sæt smøredækslet på igen, og drej i retning af ON.
E
Fejl
Skulle en fejl opstå, f.eks. pga. slidtage af en enhed, kontakt venligst serviceadressen på
P
garantibeviset. På bagsiden af denne manual finder du en tegning med alle dele, der kan
bestilles.
I
Miljø
For at undgå transportbeskadigelse leveres maskinen i en solid emballage. Emballagen er så
vidt muligt lavet af genbrugsmateriale. Genbrug derfor emballagen.
S
Defekte og/eller kasserede elektriske eller elektroniske maskiner skal afleveres på
FIN
en genbrugsplads.
N
Garanti
Garantibetingelser er beskrevet på det separat vedlagte garantibevis.
DK
90
Removal
1.
Pull the clamping ring all the way back
2.
If necessary pull the clamping head forward
3.
Pull the tool out of the taper shaft.
4. USE
Function selection switch
Fig. C
The correct position of the selection switch for each machine function is given in the diagram
(Fig.C).
Prior to starting work ensure that the front selection switch and handle selection switch are fully
engaged. Do not operate the hammer drill with selection switches in mid position. Only change
the function when the motor has come to a standstill.
1 = Chisseling
2 = Hammer drilling
3 = Drilling
Switching ON/OFF
To switch on – press the ON/OFF switch
To switch off simply release the switch.
Installing dust catcher
Fig.D
The dust catcher prevents large amounts of drilling dust entering the machine when drilling into
ceilings.
•
Remove the drill bit.
•
Slide the dust catcher over the shaft of the drill bit.
•
Place the drill bit with catcher in the drill chuck.
•
Do not use a damaged dust catcher; do not pull the dust catcher over the tip of the bit.
Auxiliary handgrip
The auxiliary handgrip can be rotated 360º around the drill head, enabling safe and comfortable
operation, for both left and right-handed users.
•
Loosen the handgrip by turning it anticlockwise.
•
Rotate the handgrip to the desire position.
•
Retighten the handgrip in the new position.
Setting depth gauge
Fig. A
•
Loosen the handgrip by turning it anticlockwise.
•
Insert the depth gauge ruler through the hole in the auxiliary handgrip.
•
Adjust the depth gauge to the desired depth.
•
Firmly retighten the auxiliary handgrip.
Ferm
Ferm
GB
D
NL
F
E
P
I
S
FIN
N
DK
07
Publicidad
Tabla de contenido
