Operating Instructions; Remote Control - MasterCool MCP44 Instrucciones De Funcionamiento Y Instalacion

OPERATING INSTRUCTIONS

The MCP44 has an electronic touch control
panel in the upper right hand corner.
Before turning unit on, ensure unit is plugged
in, water supply to pump is on, and there is
correct ventilation, as shown on page 3 of this
manual.
Note: These units may be controlled using the
3 buttons on the front panel of the cooler or
with the remote control.
On/Off
This button initiates power to the unit. When
first plugged, pressing ON/OFF will start the
unit in the default setting (pump ON and Fan
on HIGH). After its initial use, the last
operating settings (for fan and pump) will be
reinstated when the unit is turned on again.
Pressing this button when the unit is already running will turn both fan and pump off.
After A Power Failure: Once power is restored, the unit will restart in the same settings as before power was
lost.
Pump
This button toggles the pump on and off. When the LED is lit, the pump is running.
The pump must be on while operating the fan for the unit to operate as an evaporative cooler, though the unit
can be used in fan mode without the pump, if desired.
Note: For best results turn on the pump for a few minutes to wet the pads before operating the fan.
Fan
Pressing the fan button cycles the unit from HIGH, to MEDIUM to LOW speeds and then OFF.
Please Note: There is a two second delay from the pressing of the button for the fan to engage or change
speeds. This applies to the front control panel and the remote control.

Remote Control

The remote control supplied with this cooler allows you to turn the unit on
or off, control fan speed and initiate the pump. The buttons operate in the
same manner as those on the front control panel.
The remote control's range is approximately 20 feet within sight of the
cooler. It uses two AA alkaline batteries (included). A wall mountable
holder is also supplied with the cooler.
8