Installation; Preparation For Use - SKF TWIM 15 Instrucciones De Uso

4. Installation

A qualiied electrician must install a suitable plug.
Make sure that the line voltage is within the
speciied range depending on the heater type.
TWIM 15/230V
Mains supply terminal
Neutral
Line
Ground
TWIM 15/110V
Mains supply terminal
Neutral
Line
Ground
I M P O R TA N T:
The main switch in the heater is not a safety switch.
The heater needs to be unplugged from the mains
to perform any repair.
If the mains cable is damaged, it must be replaced.
230V, 50Hz
Cable color
Blue
Brown
Not connected
110V, 60Hz
Cable color
White
Black
Not connected

5. Preparation for use

• Place the TWIM 15 in horizontal position on a
surface.
• Connect the mains plug to a suitable power
supply.
• Carefully place the workpiece to be heated in
the center of the top plate.
• The heater is designed to heat up one
component at a time.
• If used in Temperature Mode, plug the
temperature probe into the connector.
Place the magnetic tip of the probe on the
horizontal surface of the bearing inner ring or
on the innermost surface of the workpiece.
• Switch on the heater from the main switch,
which is located at the rear right of the heater.
The power LED will be lit for few seconds until
the entire display and heater will be ready.
• Select the right heating mode and settings.
• Once you have inished heating the component,
attach the magnetic probe tip to the metallic
sheet on the heater's housing. This is the
temperature probe's parking spot, located at the
rear left of the heater.
EN 7