Velleman HAM06WS Manual Del Usuario página 4

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

3. Connection
• Telephone line: Connect an existing telephone line to RJ45 connector. Remark: If there is no telephone line
connected, the central will display a message ("PATh TROUBLE") and emit a sound when the alarm is
triggered. This message can be deactivated by putting all telephone numbers on "0" when programming the
central unit.
• Power supply: Connect the included power adapter to the 12VDC/1A input. This power supply will also
automatically charge the internal stand-by battery, which will supply power when the current is cut off. The
central unit will emit a sound when this internal battery is drained.
• Terminals 1 through 8:
o Terminals 1 and 2: 12VDC power supply output. This output has a constant power of 12V and can be used
to power the external sensors. Attention: terminal 1 = +; terminal 2 = - (GND).
o Terminals 3 and 4: Connection for the external siren (12VDC, 800mA). Attention: terminal 3 = - (GND)
(black wire); terminal 4 = + (red wire).
o Terminals 5 through 8: Connections for 4 external wired sensors. These sensors must be of the NC type
(NC: normally closed). Terminal 5 through 8 are assigned to ARM ZONE 1 through ARM ZONE 4. Connect
the second wire of the sensor to the ground (-) of the central unit (terminal 2 or 3). Wireless sensors will be
assigned to ARM ZONE 5 through ARM ZONE 12.
Important remark concerning terminals 5 through 8: Connect each unused terminal to the ground (-)
(=terminal 2 or terminal 3) so as to not send false signals to the central unit.
4. Alarm Unit
a. Codes
The system uses 2 security codes which can be modified by the user.
The First code is the system code. This code will be used to enter the programming mode of the unit. It is the
most important code since without it the user will not be able to program and to modify other codes. Keep this
code in a secure place. The default value is "000000".
The second code is the user code. This code will be used to deactivate the alarm system (DISARM). The
default value is "1234".
HAM06WS_v2
4
VELLEMAN

Publicidad

Tabla de contenido
loading

Tabla de contenido