Tennant 110 Manual Del Operador Y De Accesorios página 3

Figure 1
Lower
Handle
Sweeper
Frame
Upper
Handle
Lower
Handle
Figure 2
Hopper
Handle
Sweeper
Hopper
Figure 3
- Adjusting Main
Figure 5
Broom
Assembly
ASSEMBLING HANDLE
1. Place ends of lower handle into holes of sweeper
frame. Attach with screws (see
Figure 1).
2. Attach upper handle to lower handle using
machine screws, lockwashers, and nuts (see
Figure 2).
3. Hopper handle should be attached to the dirt
hopper with screws provided (see Figure 3).
ASSEMBLING SIDE BROOM
Broom
Pulley
Broom
Arm
Outside
Tracking
Hairpin Clip
Clevis Pin
1. Drive belt should be positioned on the pulley when
received. Check to ensure belt is on the pulley,
and between belt guides.
2. With the side arm positioned as shown in Figure 4,
place the belt between the walls of the side broom
arm. Place the outside tracking belt over the rear
wheel and above the mounting bracket. The inside
tracking belt must be UNDER the mounting
bracket.
3. Attach the side broom arm to the mounting
bracket, by aligning the holes in the arm with the
holes in the mounting bracket. Insert clevis pins
and secure with hairpin clips.
4. Place side broom bumper on the side broom
pulley with the outside flange toward side broom.
Attach side broom to the side broom pulley with
screws, lockwasher and washers.
5. Lower side broom arm and replace hopper.
6. If side broom rotates in the wrong direction, the
belt is not installed correctly.
Home Find... Go To..
Operation
MAIN BROOM
Refer to Figure 5.
1. The main broom has been preset at the factory for
maximum sweeping efficiency.
2. If adjustments are required for surfaces or wear,
this can be done by turning the adjustment knob.
The height indicator will show the position of the
broom as you make your adjustment (Figure 5).
3. For best operating performance, the bristles of the
broom should just touch the floor.
NOTE: If the main broom is set too low, the sweeper
will be hard to push.
Figure 4
SIDE BROOM
Refer to Figure 6.
1. The side broom should be lowered and used when
Side
sweeping along curbs or walls; it may also be
Broom
used when sweeping open areas.
Broom
Bumper
Inside Tracking
Side
Broom
Belt Guides
Arm
Mounting
Figure 6
Bracket
2. Side broom height should be adjusted to have
approximately
Adjustment can be made by turning the
adjustment knob.
OPERATING PUSH SWEEPER
Push sweeper forward at normal walking speed; it
does not operate when pulled backwards.
3
Side Broom Arm
Sweeper
- Adjusting Side Broom
/ of the bristles touching the floor.
1
3