5 Overview image
An overview illustration of the gas hot air blower is provided in Figure
1 Heat protection spiral
2 Holding eye
3 Gas valve
4 Gas cartridge
5 Piezo ignition
6 Using the tool
WARNING
Faulty operation and malfunction of the gas hot air blower result in the risk of sever injury or possible
mortal danger.
f Always keep the nozzle a minimum distance of 2 cm away from the surface.
f Always maintain a distance of 40 cm to walls and ceilings, if a flame guard is not used.
f Never leave the gas hot air blower switched on if unattended.
f Avoid a gas back-up in small rooms, gas back-up can cause gas deflagration.
f Before storing the gas hot air blower after use, let it cool down, and then remove the gas cartridge
correctly.
f Do not use the gas hot air blower for longer than 60 minutes without interruption.
f Do not use a gas hot air blower that leaks, is damaged, or is not functioning properly (gas odour).
f Do not use the gas hot air blower in the vicinity of flammable materials.
f Do not expose the gas hot air blower to a temperature of, or direct sunlight above 50°C.
f Slide the heat protection spiral
hook it into the holding eye
f If desired, fit the reflector nozzle on the barrel (Figure
f Screw the gas cartridge
f Turn the gas valve
3
f Immediately after opening the gas valve
several times (Figure
f Regulate the gas supply by turning the gas valve (Figure
f Pay attention to the distance-dependant temperature zones without nozzle (Figure
nozzle (Figure
).
I
Temperature zones (distance-
dependant)
Without nozzle
With flat nozzle
(Figure
) on the barrel of the gas hot air blower (Figure
1
A
(Figure
).
2
A
(Figure
) into the gas hot air blower (Figure
4
A
(Figure
) to the left to position 1 (Figure
A
activate the Piezo ignition
3
).
F
2 cm
+ 750°C
+ 500°C
Operating instructions • E4500 • 05-2016 • 391-90002
.
A
) of the gas hot air blower.
C
).
D
).
E
(Figure
5
).
G
4 cm
6 cm
+ 575°C
+ 450°C
+ 350°C
+ 200°C
Overview image
) and
B
), if necessary,
A
) and with flat
H
8 cm
+ 350°C
-
5