Publicidad
Idiomas disponibles
Idiomas disponibles
1.- ASSEMBLY INSTRUCTIONS.-
Take the unit out of its box and make
sure that all of the pieces are there
Fig.0:
The assistance of a second person
is recommended when assembling
this unit.
(1)
Main body.
(2)
Seat rail.
(3)
Rear rail support.
(4)
Front stabiliser bar with wheels.
(5)
Foot rest support.
(16L) Left footrest.
(16R) Right footrest.
(27) Seat.
(32) Electronic monitor;
(21) Left rail cover (L).
(22) Right rail cover (R).
(76) Adaptor
Nuts & Bolts.
(26) Screw cap
(33) Coach bolt DIN603 M-10x75.
(34) Curved washer M-10x25x1.5.
(35) Cap nut M-10.
(36) Coach bolt DIN603 M-10x50.
(37) Flat washer M-10.
(38) Allen screw M-8x15.
(39) Flat washer M-8.
(40) Allen screw M-8x22.
(46) Flat washer M-6.
(47) Allen screw M-6x15.
(48) Footrest rotation shaft.
Allen key 4mm
Box spanner with star screw-driver
Combination spanner.
2.- FITTING THE STABILISER
BARS.-
Bring the front stabiliser bar with
wheels (4) to the main body (1) Fig.1,
insert
bolts
(33),
washers (34) the cap nuts (35). Use
the 6mm Allen key to tighten securely.
fit
the
curved
3.- MOUNTING THE FOOT
RESTS.-
Firstly, position the left foot rest (16L)
in the "U" of the support (5) Fig.1A.
Insert pin (48) through the foot rest
hole and insert screw (47) in each
end, in addition to washer (46) y and
then firmly tighten with the 4mm Allen
wrench.
Repeat the operation described above
for the right foot rest (16R), as shown
in Fig.1A.
Move the foot rest support (5) towards
the main frame (1) Fig.1.
Insert screws (36), mount the curved
washers (37), and cap nuts (35) and
then firmly tighten with the 6 mm Allen
wrench.
4.- MOUNTING THE ALUMINIUM
RAIL.-
Insert
aluminium
direction indicated by the arrow, into
the central frame (1) Fig.2.
Insert screws (38) with washers (39)
Fig.2 and then firmly tighten with the 6
mm Allen wrench.
5.- MOUNTING THE SEAT.-
Once the aluminium rail has been
assembled, insert seat (27) in rail (2),
in the direction indicated by the arrow,
as shown in figure Fig.2.
Insert
the
mounting screws (40) together with
the end caps (26) and then firmly
tighten with the 6mm Allen wrench.
Mount end caps (21) and (22) at the
end of the aluminium rail as shown in
Fig.2.
10
rail
(2)
seat
travel
stops
in
the
by
Publicidad
