babymoov Babyphone Visio Care 2 Instrucciones De Uso página 15

This babyphone can work with several transmitters (up to 4 transmitters). To create the connection please go through
the following steps:
a. Switch on the units.
b. Rapidly press the Menu button (12). The main
menu will then appear on the screen.
c. Use the "Up/Down" selection arrows (13)
to select "Matching"; then press the Menu
button (12) and the screen will display
the menu of the transmitter:
d. Use the «Up/Down» selection arrows (13) to select
"BABY"; then press the Menu button (12). Use the
"Up/Down" selection arrows (13) to assign a
number to the transmitter you want to connect (normally the number 1 is automatically selected for the first
transmitter connected.)
N.B. If you select a number already used by another transmitter then the new connection will ignore the old one and
the transmitter originally connected will no longer be able to communicate with the receiver.
e. Press the Menu button (12) to confirm the number of the selected camera, then use the "Up/Down" selection
arrows (13) to select "PAIR"
f. Repeat steps 2 and 3 above with the new transmitters that are added. If the connection has worked the N will
change to Y and the screen will then show you the view it has captured with the new transmitter's camera.
g. Use the «Up/Down» selection arrows (13) to select "Return main" followed by "Exit" to return to normal use. The
menu on the screen will disappear automatically if no button is pressed within 3 seconds.
h. To see the images of the various transmitters that are connected, repeat steps b to c and select the
corresponding numbers.
7. Follow the instructions below to display the image of the connected cameras:
a. Press the remote camera control button (21) to turn on the screen.
b. Press the Menu button (12) and use the "Up/Down" selection arrows (13) to select "MATCHING". Then press "Menu"
(12) again to display the "UNIT SELECT" menu.
c. Use the "Up/Down" selection arrows (13) to select "BABY" then press the Menu button (12).
d. Use the Up/Down" selection arrows (13) to select the number of the camera you want to monitor (1, 2, 3, 4 or
SCAN), then press the Menu button (12). The screen (17) will display the image recorded by the selected camera.
If you choose the "SCAN" option, the screen (17) will display images from each camera in turn for 5 seconds. If one
of the cameras detects a sound, the SCAN function will display the image of the camera where the sound was
detected for 15 seconds before scanning once more.
e. Press the remote camera control button (21) again to return to VOX mode. When no sound is detected, the screen
(17) shuts off to save energy. When the "SCAN" option is selected, the camera functioning light (20) flashes regularly
to show that the receiver is in SCAN mode.
8. To disconnect a camera:
a. Press the remote camera control button (21) to turn on the screen.
b. Press the Menu button (12) and use the "Up/Down" selection arrows (13) to select "MATCHING". Then press the
Menu button (12) again to display the "UNIT SELECT" menu.
c. Use the "Up/Down" selection arrows (13) to select "BABY" then press the Menu button (12).
d. Use the "Up/Down" selection arrows (13) again to select the number of the camera you want to disconnect, then
press the Menu button (12).
16
BABYPHONE VISIO CARE 2 • Instruction manual