Hoover Feejet Evo FM18LI011 Manual De Instrucciones página 9

DISCHARGE INDICATOR: When the batteries are fully discharged, the indicator will flash about 20 times
before cleaner switches off automatically.
Crevice Tool / Dusting Brush
The accessory is stored at the rear of the main body, they can be fitted directly onto the handheld unit.
Take it out from the rear of the main body before use, [15a] and put it back after use. [15b]
IMPORTANT: For storage, the product handle can be fixed into the holder [5b] or it can be folded for
easy storage. [5a]
CLEANER MAINTENANCE
Emptying the Dust Container
Hold the handheld cleaning unit over a bin and press the dust bin release flap button to empty the dust
container. [8]
Cleaning the Filter
1. Press the handheld unit release button, lift the handheld unit from cleaner main body. [6]
2. Press the dust container release button and remove the dust container. [9]
3. Lift the filter from the dust container. [10]
4. Wash the filter in lukewarm water and leave to dry for 24 Hrs. [11b,12] Once thoroughly dry return to
the dust container.
5. If required, wash the dust container in lukewarm water. [11a] Ensure it is fully dry before returning to
the main body of the cleaner.
6. Reassemble the handheld unit and return to the cleaner main body. [13,14]
NOTe: Do not use hot water or detergents when cleaning the filters. In the unlikely event of the filters
becoming damaged, fit a genuine Hoover replacement. Do not try to use the product without a filter fitted.
IMPORTANT: For optimum performance, always keep your filter clean. We recommend that the filter should
be washed at least once a month.
Changing and Cleaning the Agitator**
IMPORTANT: Always switch off the cleaner before changing the agitator.
1. Open the Agitator Release Button outward. [16]
2. Remove the Agitator. [16]
3. Replace with the new Agitator or clean it.
5. Re- fit the Agitator and press the Agitator Release Button until it locks in place.
Battery Replacement
When the batteries fail to maintain charge, please contact the Hoover Customer Service Centre to obtain a
replacement battery.
WARNING: Only use approved replacement parts for your vacuum cleaner. Using parts not validated by
Hoover are dangerous and will invalidate your guarantee.
WARNING: Always make sure your device is switched off before changing your batteries.
IMPORTANT: Always fully discharge the batteries before removal and ensure charger is unplugged.
1. Run the unit until the batteries are completely empty. When the battery is fully discharged, the
indicator will flash about 20 times before the cleaner switches off automatically.
2. Release the handheld unit from the main body of the cleaner. [6]
3. Press the dust container release button and remove the dust container. [9]
4. Remove 2 screws and open the unit. [17]
5. Disconnect the cables and remove the batteries from the housing. [18]
6. Fit the new battery and re-assemble the vacuum cleaner by reversing steps 2 – 5 above.
End of Product Life Battery Disposal
f the vacuum cleaner or used battery is to be disposed of the batteries should be removed. Used batteries
I
should be taken to a recycling station and not disposed with household waste. To remove the batteries,
please contact the Hoover Customer Service Centre or proceed according to the following instructions:
IMPORTANT: Always fully discharge the batteries before removal and ensure charger is unplugged.
*Nozzle design may vary according to models **Motorized Nozzle only
4
GB