PRODUCT COMPONENTS
Main Cleaner
A. On/Off Switch and Mode Selector
B. Main Body
C. Foldaway Handle Release Button
D. Handheld Release Button
E. Handheld Unit
F. Nozzle Release Button
G. Motorized Nozzle*
Floor Nozzle*
G1.
H. Agitator Release Button**
I.
Crevice Tool / Dusting Brush
J.
Product Holder
K. Charger
PREPARING YOUR CLEANER
1. Unfold the handle to the main body until it locks in place. [1]
2. Attach the nozzle to the main body, push firmly until it locks in place. [2]
3. For first use, charge your cleaner for 12Hrs. After first use the normal charging time is 6 Hrs.
4. When the product is charging the middle indicator light will be red and will turn blue when fully
charged.
5. The product holder can be fixed to the wall using the screws provided. [5b]
NOTe: To remove the nozzle, press the nozzle release button and pull away from the main body.
NOTe: Use only the charger supplied with your cleaner to recharge.
IMPORTANT: When charging the cleaner, the On/Off switch must be OFF.
It is normal for the charger to become warm to touch when charging.
If the operating time reduces after repeated use let the cleaner run until it stops then recharge it for 12Hrs,
repeat this monthly for optimum performance.
Unplug the charger in the event of prolonged absence (holidays, etc.). Recharge product again before use
as battery may self discharge over increased periods of storage.
USING YOUR CLEANER
Main Cleaner with Motorized Nozzle [G]*
Turn the cleaner on by sliding the On/Off switch to the following settings [4]:
• HARD FLOOR: First position of On/Off switch ideal for hard floor surfaces, the cleaner is in the lower
settings
and the agitator** and nozzle LED lights** are OFF.
,
• CARPET: Second position of On/Off switch ideal for carpets and rugs, the cleaner is in the higher
settings
and the agitator** and nozzle LED lights **are ON.
,
Main Cleaner with Floor Nozzle [G1]*
Turn the cleaner on by sliding the ON/OFF switch forwards to one of the following settings [4]:
Power Level I: First position of On/Off switch. Ideal for simple cleaning tasks, the cleaner is in the lower
setting.
Power Level II: Second position of On/Off switch. For tougher cleaning tasks, the cleaner is in the higher
setting.
Handheld Cleaner
1. Press the handheld release button, lift the handheld unit from the main body.
2. Turn the handheld cleaner on by sliding the On/Off switch forward.
*Nozzle design may vary according to models
Handheld Cleaner
L. On/Off Switch
M. LED Indicator
N. Dust Container Release Button
O. Dust Container
P. Dust Bin Flap release Button
Filter
Q. Cloth Filter
[7]
**Motorized Nozzle only
3
GB
[6]