Adjusting Bass, Midrange, Treble, And Balance Of Speakers - Teac AG-H600NT Manual Del Usuario

Adjusting Bass, Midrange, Treble, and Balance of Speakers

1 Select the item to adjust.
Each time you press the VOLUME/SET knob, the display changes
as follows:
VOLUME (volume)
TREBLE
BALANCE
DIMMER
< You can also use the SET button on the remote cntrol unit.
BASS
Adjusts the level of low frequency sound range. The level can
be adjusted from –12 to +12.
MID
Adjusts the level of middle frequency sound range. The level
can be adjusted from –12 to +12.
TREBLE
Adjusts the level of high frequency sound range. The level can
be adjusted from –12 to +12.
BALANCE
Adjusts the balance of the volume level between left and right
speakers.
DIMMER
Adjusts the dimming level of the display in 3 levels using the
DIMMER button of the remote control unit.
1 2
BASS
MID
Each time you press the DIMMER button, the display changes
as follows:
NORMAL (Normal)
DIMMER (Dimmed)
LIGHT OFF (Display off)
< This setting is not memorized when the unit turns into standby.
The next time the unit is turned on, the display is illuminated as
normal.
< When the unit is operated during the setting is "LIGHT OFF", the
display turns normal briefly and will turn off again.
2 Turn the VOLUME/SET knob to change the setting.
< You can also use the VOLUME buttons (+/–) on the remote cntrol
unit.
Leave the unit idle for 3 seconds to exit the setup mode.
3
Tone Direct
Press the TONE DIRECT button to cancel the tone adjustments
temporarily.
When this function gets active, the Tone Direct indicator lights
up temporarily.
FM
CH01
< To cancel the Tone Direct function, press the button again.
< When this function is active and no operation is done for about
5 seconds, the display is turned off regardless of the dimmer
setting.
Tone Direct indicator
98.1MHz
13