Publicidad
Idiomas disponibles
Idiomas disponibles
Description of parts (Fig. 1)
A Cool tip
B Conic heating element
C Base stand
D LCD display
E On/off switch
F Button to increase temperature
G Button to reduce temperature
H Handle
I Mains cable with anti-twist device
Operation
· Unfold the base stand and place the appliance on
a flat, smooth, non-heat-sensitive surface.
· Connect to the mains power supply.
· Using the on/off switch (E), switch on the appli-
ance (Fig. 2).
· Set the desired temperature (80°C – 210°C).
The preset temperature is 180°C.
To increase the temperature, press the button
(F).
To reduce the temperature, press the button
(G).
Note: The temperature can be adjusted by 5°C
at a time by tapping on either of these buttons. To
adjust the temperature more quickly, hold down
the appropriate button.
· The LCD display flashes three times when the
temperature is set. Once the set operating tem-
perature has been reached, the LCD display
shows the temperature. The LCD display flashes
until the desired temperature has been reached.
After the desired temperature has been reached,
the flashing stops.
· After use, switch off the appliance with the on/off
switch (Fig. 2). Hold the on/off switch to do this.
The LCD display must go out.
· Disconnect from the mains power supply.
· Allow the appliance to cool down.
TITANIUM, CERAMIC and TOURMALINE
(depending on model)
Negative ions have an antistatic effect and are gen-
tle to the hair. They close the scale layer, creating
a smooth, silky hair surface and lock in the natural
moisture of the hair, thereby creating the ultimate
shine.
Tips for successful styling
Important: The appliance comes with a protec-
tive glove - this must be worn (Fig. 4) on the hand
used to wrap the hair around the heating element
in order to protect the fingers. However, the glove
does not protect the fingers if they are exposed to
prolonged contact with the heating element.
· Always test the curling tongs on a small section
of hair first.
· Divide your hair into sections about 2 cm thick
and 4 cm wide.
· Hold the curling tongs vertically. Wind the section
around the conic curling tongs from the base to
the tip to create a spiral. (Fig. 4)
· When the entire section has been wound around
the curling tongs, hold it for a few seconds before
carefully removing the curling tongs from the tight
curl. Do not brush or comb hair while it is warm.
· After curling the desired sections of hair in this
way, the curls can be loosened with the fingers
and the hair can be styled.
Tip: To make it easier to curl hair around the
neck area, hold the curling tongs horizontally
instead of vertically.
· To create large curls, wind the section of hair
around the base (Ø25 mm) of the curling tongs
(Fig. 3) and use the tip (Ø13 mm) of the curling
tongs for smaller curls (Fig. 3).
Cleaning and care
· Before cleaning the appliance, disconnect from
the mains and allow it to cool down.
· Do not immerse the appliance in water.
· Only wipe the appliance with a soft cloth, which
may be dampened slightly. Do not use solvents
or abrasives!
Disposal in EU countries
Do not dispose of the appliance with domes-
tic refuse. As part of the EU Directive
governing the disposal of electrical and elec-
tronic equipment, the appliance is accepted
free of charge by local waste collection
points or recycling centres. Correct disposal
will ensure environmental protection and
prevent any potentially harmful impacts on
people and the environment.
Disposal in non-EU countries
At the end of its service life, please dispose
of the appliance in accordance with statutory
requirements.
ENGLISH
de
en
fr
it
es
pt
nl
sv
no
fi
tr
pl
cs
sk
hu
sl
ro
bg
ru
uk
el
ar
9
Publicidad
