Maintenance; Battery Replacement; Cleaning; Calibration Checking - Chauvin Arnoux AmpFLEX A100 Serie Manual De Instrucciones

When performing maintenance, use only the specified replacement parts. The
manufacturer cannot be held responsible for any accident occurring subsequent to
repair work carried out by parties other than its own after-sales service team or agreed
repair personnel.

5.1 BATTERY REPLACEMENT

The battery must be replaced when the green LED flashes or fails to light up when the box is
used.
Remove the flexible probe from the circuit to be measured.
Set the box switch to ‚OFF'
Disconnect the box from the measurement device.
Unscrew the two fastening screws on the box.
Replace the used battery with a 9V alkaline battery (type 6LF22)
Close the box again, refitting the two screws.

5.2 CLEANING

The air-core and its latching system require no special care. Simply ensure that no foreign
body is allowed to obstruct the latching mechanism.
Clean the box with a cloth slightly dampened in soapy water. Clean off with a damp cloth.
Dry immediately afterwards with a cloth or with blown air at 80°C maximum.

5.3 CALIBRATION CHECKING

As with all test and measurement equipment, the calibration will periodically need to be
checked. If your clamp is used for fewer than 4 hours per day, we recommend at least
one calibration test per year. For heavier use, we recommend more regular calibration testing.
Contact the following COFRAC-accredited meterology laboratories concerning the testing and
recalibration of your equipment:
CHAUVIN ARNOUX Pont l'Evêque : Tel.: 33 2 31 64 51 55
MANUMESURE Lyon :
MANUMESURE Caen :
or Chauvin Arnoux subsidiary or Agent in your country.

Maintenance

Repairs under or out of warranty: please return the instrument to your distributor.
5. MAINTENANCE
Tel.: 33 4 78 26 68 04
Tel.: 33 2 31 83 60 38
Fax : 33 2 31 64 51 09
Fax : 33 4 78 26 79 73
Fax : 33 2 31 84 55 39
19