Additional Components; Dust Collection Attachment - Kreg Jig K4 Guia De Inicio Rapido

Tips
6 Tips to Reduce Wood Splitting
Test Pieces
1
Test the joint with some scrap workpieces cut from the same stock as your final workpiece.
Make sure you're using Kreg Screws
2
Kreg screws have several features designed to limit/eliminate wood splitting in your joints.
Use Fine Thread Screws in Hardwood
3
Coarse Thread screws displace more wood thanks to a more aggressive thread pattern.
Screw it In, Back it Out
4
By driving your screw half way in, back out, and then in again, you'll reduce excess wood in the
hole and reduce the chance for splitting.
Reduce Friction
5
By applying some bee's wax or other lubricant to the screw, you'll reduce the friction of the
screw entering the workpiece.
Clamp, Clamp, Clamp
6
Correctly clamping your joints reduce workpiece movement/vibration, both of which can cause splitting.
800-447-8638
For more detailed instructions, please
visit us online at www.kregtool.com.

Additional Components

Face Clamp
TM
Perfectly fl ush Kreg Joints , in no time.
TM
For the best results, place the Face Clamp™
on the joint directly over the center of the
joint line. Make sure the large pad of the
clamp is on the face side of the joint (opposite
the Pocket-Holes) to keep the workpieces
perfectly flush. Clamp firmly to reduce the
possibility for workpiece movement.

Dust Collection Attachment

Keep a clean shop.
This simple attachment is a real time saver. It
snaps easily into place on the back of your
jig providing compatibility with any standard
1-1/4" vacuum hose. In addition to a clean
shop, it also provides faster/easier drill
strokes and extends the life of your drill bit.
www.kregtool.com