Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CAYMAN AQUARIUMS
IT
TECHNICAL CHARACTERISTICS
BRACKETS
ARCLIGHT lamps come complete with 2 elegantly designed, very strong polycarbonate brackets (C/1). Both can be adjusted from 0 to 8 cm, providing
extremely flexible use with all different models of aquariums. Both brackets come with bolts and rubber caps and are suitable for glass up to 15 mm thick.
EN
LAMPS
All ARCLIGHT lamps are complete with fluorescent bulbs, reflector dish and waterproof bulb socket. To give your fish and plants the best possible light,
choose among SEALIFE, FRESHLIFE and TOPLIFE, the Ferplast neon tubes, especially designed for marine and freshwater aquariums.
ELECTRONIC POWER SUPPLY
The electronic power supply, with bulbs at the water surface and a reflector dish, ensures appropriate lighting of the aquarium environment, while being
fully safe and easy to use and maintain. The electronic power supply of the bulbs, compared to traditional power, guarantees:
FR
•
energy savings in compliance with European Directive 2000/55 on the use of low energy consumption devices;
•
longer lifetime of the bulbs;
•
stabler light: more similar to that of the sun (the flickering of traditional lighting is not perceptible);
•
better quality light: it remains constant almost until the end of the bulb's lifetime;
•
lower temperatures: the electronic power supply disperses less heat;
•
greater safety: when the bulb is burning out, a sophisticated electronic protective device disconnects power, making it safe;
•
lighter: the electronic power suppliers are much lighter.
D
INSTALLATION
ABOVE THE TANK OF A CAYMAN OPEN AQUARIUM
•
Remove the lamp from the package and connect the 2 brackets, sliding them along the guides at the bottom of the lamp itself (B).
•
Adjust the 2 brackets, sliding them under the lamp, so that they can be positioned above the tank of your aquarium.
NL
•
Secure the bracket to the tank using the bolts and rubber caps (C/4-5), positioning the lamp at the center of the aquarium so that light is distributed
evenly.
ON THE CEILING
•
Put the inserts into the 2 ends of the lamp (C/7).
•
Connect the lamp to the ceiling above the aquarium using two cords and securing them to the inserts using the holes.
ES
ABOVE THE TANK OF A STAR AQUARIUM
•
To add a lamp to the STAR aquarium, open one of the two side heads of the aquarium's lid and remove the piston, as shown in the relative operating
manual.
•
Put the inserts into the 2 ends of the lamp (C/6a).
•
Insert the lamp into the guides under the lid using the tabs of the inserts (C/6b); lamps that are already present may need to be repositioned.
•
Then close the lid's head and reposition the relative piston.
SK
MAINTENANCE
The ARCLIGHT lamps, once installed, do not require special maintenance, except for at least annual replacement of the bulbs to maintain an optimum
light spectrum.
To replace a bulb (C/8):
•
Disconnect the plug from the power supply.
CS
•
Unscrew the two waterproof ring nuts of the bulb socket.
•
Remove the bulb by rotating it a quarter turn until both pins are aligned with the bulb socket's slot.
•
In the same way, insert the new bulb by rotating it a quarter turn (you will hear a click).
•
Carefully tighten the ring nuts.
1
Adjustable brackets (8 cm)
C
HU
2
Waterproof bulb socket
3
Reflective plates
1
SV
DA
RU
6
PL
8
4
5
6
3
a
b
Bracket bolts
Rubber caps
Attachment for STAR aquarium
2
7
7
Attachment for ceiling
8
Bulb replacement
5
4
8
Publicidad
Tabla de contenido
