Ci365 Vacpan™ Installation Instructions; Installation Tips; Under Cabinet Installation - NuTone PUREPOWER Serie Manual De Instalación

CI365 VACPAN™ INSTALLATION INSTRUCTIONS
NOTE: Please read instructions prior to installation.

INSTALLATION TIPS

Plan the location of your CI365 VACPAN to be conveniently
•
located for sweeping clean-ups.
Also consider ease of access of vacuum tube piping
•
connections during installation.
The leading edge of the CI365 VACPAN must sit flush with
•
the finished floor.
For maximum clearance, use part no. CV382S universal
•
short 90° elbow for connection to CI365 VACPAN.
Do not glue the connection between CI365 VACPAN and
•
elbow to allow for future removal.
Prior to final installation, check for an airtight seal between
•
CI365 VACPAN and elbow. Teflon tape may be used if
required.
Allow for 1/2" vertical play in vacuum tube piping at
•
CI365 VACPAN location, so that final piping connections
can be made.

UNDER CABINET INSTALLATION

Refer to illustration at bottom of page.
CI365 VACPAN requires a minimum 2¼" toe kick height.
•
Once the CI365 VACPAN location is determined, cut a
•
6¾" long x 1¾" high slot in the cabinet toe kick to accept the
CI365 VACPAN.
AH0006A
UNDER CABINET INSTALLATIONS
QUICK TRIM
COVER PLATE CV382S
UNIVERSAL
CI365 VACPAN™
SHORT 90° ELBOW
CABINET FLOOR
SUB FLOOR
Run vacuum tube piping and low voltage wire from the main
•
piping line to the CI365 VACPAN location.
Access for final piping connections must be made.
•
A B
CCESS FROM ELOW
If access is available from below, cut an access hole through
the subfloor underneath the cabinet, positioned so that final
piping connections can be made by reaching through the
access hole.
A C
CCESS THROUGH ABINET
Access can be made through the finished cabinet floor. Cut
a 2¾" x 3½" access hole, positioned so that final piping
connections can be made by reaching through the access
hole. CI366 Trim Plate can be used to cover the hole after
installation.
A C
CCESS THROUGH ABINET
Access can be made through the cabinet toe kick by cutting
up to 10½" x 4" slot and using the CI365 VACPAN Quick Trim
Cover Plate (CI366 Trim Plate sold separately). If required,
score back of Quick Trim Cover Plate with a knife and snap
along grooves for height adjustment.
Attach low voltage wires to CI365 VACPAN terminal
•
connections marked "low voltage only" .
Slide CI365 VACPAN into mounting slot and secure to toe kick
•
using two no. 6 screws provided.
Reach through access hole and make final piping
•
connections.
CI366
TRIM PLATE
ROUGH-IN
OPTIONS
SUB FLOOR
19
F
LOOR
T K
OE ICK