Numark MIXTRACK Guia De Inicio Rapido página 5

18. CUE – The CUE button will return and pause the track at the last set cue point. For temporary play of
the cue point, you can hold down the CUE button. The track will play for as long as the button is held
down and will return to the cue point once it has been released.
You can hold down CUE and PLAY / PAUSE simultaneously to start playback from the cue point.
Release both buttons to allow playback to continue.
19. SYNC – Automatically matches the corresponding Deck's tempo with the other Deck's tempo.
20. PITCH FADER – Controls the track's playback speed. An LED next to the fader will light up when set
at 0%.
21. PITCH BEND ( + / – ) – Press or hold down either of these buttons to temporarily adjust the track's
playback speed. When released, the track playback will return to the speed designated by the PITCH
FADER.
22. KEYLOCK – If you have changed the pitch of the track, you can press the KEYLOCK button to return
the track's pitch to its original key. The track's tempo will remain at the speed designated by the PITCH
FADER.
23. VIEW – Press this button to expand or collapse the Browser Tree view of your files.
24. TICK – Press this button to activate or deactivate the Tick feature, a metronome-style "click" heard in
the Cue Channel.
25. EQ KILL SWITCH – Pressing down on these buttons removing that frequency band (BASS, MID, or
TREBLE) from the music on that deck. The button will illuminate when the EQ kill feature is engaged.
To disengage it, press the button again.
26. EFFECT ON / OFF – Press this button to activate or deactivate the effect. The button's LED will
illuminate when the effect is on.
27. EFFECT SELECT – Turn this knob to select an effect to apply to the channel, which will be displayed in
the software. You can also press the knob to move automatically to the next effect.
28. EFFECT CONTROL – Turn this knob to adjust the parameter of the effect, which will be displayed in
the software.
29. MODE – Press this to switch between Manual Mode and Autoloop Mode, which changes the functions
of the LOOP CONTROL buttons.
Manual Mode:
• IN – Press this to set a "Loop In" point where your loop will begin.
• OUT – Press this to set a "Loop Out" point where your loop will end.
• RELOOP – Press this to jump to the start of the loop and enable it. If the Deck is already looping
when you press it, the Audio Pointer will jump to the start of the loop and continue. (If no loop is
set, nothing will happen.)
Autoloop Mode:
• 1/2 X – Press this to halve the length of the loop.
• 1 BAR – Press this to set a 1-bar loop automatically and enable it.
• 2 X – Press this to double the length of the loop.
3