Installation; Points To Be Paid Attention To When The Relocation Of The Refrigerator; Electrical Connection; Important - Beko RDNT340I20S Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

3

Installation

B
In case the information which are
given in the user manual are not
taken into account, manufacturer will
not assume any liability for this.
Points to be paid attention
to when the relocation of the
refrigerator
Your refrigerator should be
1.
unplugged.Before transportation of
your refrigerator, it should be emptied
and cleaned.
Before it is re-packaged,
2.
shelves, accessories, crisper, etc.
inside your refrigerator should be
fixed with adhesive tape and secured
against impacts. Package should
be bound with a thick tape or sound
ropes and the transportation rules
on the package should be strictly
observed.
Original packaging and foam
3.
materials should be kept for future
transportations or moving.
Before you start the refrigerator,
Check the following before you
start to use your refrigerator:
Clean the interior of the
1.
refrigerator as recommended in the
"Maintenance and cleaning" section.
Connect the plug of the
2.
refrigerator to the wall socket. When
the fridge door is opened, fridge
internal lamp will turn on.
When the compressor starts to
3.
operate, a sound will be heard. The
liquid and gases sealed within the
refrigeration system may also give rise
to noise, even if the compressor is not
running and this is quite normal.
Front edges and both sides of
4.
the refrigerator may feel warm. This is
normal. These areas are designed to
be warm to avoid condensation.

Electrical connection

Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.

Important:

The connection must be in compliance
with national regulations.
• The power plug must be easily
accessible after installation.
• Electrical safety of your refrigerator
shall be guaranteed only if the earth
system in your house complies with
standards.
• The voltage stated on the label
located at left inner side of your
product should be equal to your
network voltage.
• Extension cables and multi plugs
must not be used for connection.
11
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido