Auto-Off; Setting The Temperature; Energy Saving; Setting Water Hardness - DeLonghi ECAM23210B Manual De Uso

Auto-off

Please note
The appliance is set to turn off automatically if
not used for 2 hours�
The time can be changed so that the appliance
switches off after 15 or 30 minutes, or after 1,
2 or 3 hours�
1. Press the P button to enter the menu;
2� Turn the selection knob (fig� 8) until the
light comes on;
3. Press the button to select the function;
4� Turn the selection knob until the lights corre-
sponding to the number of hours before the
appliance goes off automatically come on:
15 minutes
30 minutes
1 hour
2 hours
3 hours
5. Press the button to confirm;
6. Press the button to exit the menu�
Auto-off is programmed�

setting the temperature

To modify the temperature (low, medium, high)
of the water used to make the coffee, proceed
as follows:
1. Press the P button to enter the menu;
2� Turn the selection knob until the
comes on;
3. Press the button;
4� Turn the selection knob until the lights corre-
sponding to the required temperature come
on:
LOW
MEDIUM
HIGH
5. Press the button to confirm;
6. Press the button to exit the menu�

energy saving

Use this function to enable or disable energy
saving mode� When activated, it reduces energy
consumption while the machine is on in com-
pliance with current European regulations�
1. Press the P button to enter the menu;
2� Turn the selection knob until the light e co-
mes on�
3. Press the
4. Press the
deactivate, the energy saving mode;
5. Press the
When the function is active, the e light remains
on�
Please note!
A few seconds may elapse between energy sa-
ving mode and delivery of the first coffee as the
appliance must heat up again�

setting water hardness

For instructions on setting water hardness, see
page 17�

Install filter

For instructions on how to install the filter, see
the section "Installing the filter" on page 17�

Replacing the filter

For instructions on how to replace the filter, see
the section "Water softener filter" on page 17�

Default values (reset)

This resets all menu settings and programmed
quantities back to the default values�
1. Press the P button to enter the menu;
2� Turn the selection knob until the
light
lights come on;
3. Press the
5. Press the

statistics function

This displays statistics relating to the machine�
To display, proceed as follows:
1. Press the P button to enter the menu;
2� Turn the selection knob until the
comes on;
3. Press the
4� When the selection knob is turned and the
corresponding light flashes, the following
information is displayed:
- how many coffees have been made;
- how many times the machine has been
descaled;
- the total number of litres of water deli-
vered;
11
button� The ok light flashes�
button to activate, or
button to exit the menu�
button� The ok light flashes;
button to confirm and exit�
button;
to
light