To Start And Stop Cord Powered Mower (Model Lc 141C) - Husqvarna LC 141VLi Manual De Instrucciones

To stop the drive (model LC 141VLi)
To stop the drive but keep the motor running, release
only the propulsion bar.
To stop the motor
1. Stop the motor by releasing the motor brake handle.
2. Hold down the ON/OFF button (1) on the panel until
the green LED (2) goes out.
The product will be turned off automatically if inactive
for 10 minutes. Never leave the product unattended
when the safety key is in position "1".
3. Open the protective cover and turn the safety key to
position "0".
4. Recharge the battery if weak. For more information,
To charge the battery on page 113 .
see
5. Remove the battery from the product by pressing the
two release buttons and pulling out the battery.
71 - 001 - 03.11.2016
To start and stop cord powered mower
(model LC 141C)
Before starting:
• Keep people and animals well away from the
working area.
• Perform daily maintenance. See instructions in the
Maintenance schedule on page 116 .
section
To select an approved cable (LC 141C)
If extension cables are used, these must comply with the
minimum cross-sections in the table below:
Voltage Cable length
220-240V/ 50Hz Up to 20 m
220-240V/ 50Hz 20–50 m
• Mains cables and extension cables are available
from your local approved service agent for
Husqvarna outdoor products.
• Only use extension cables specifically designed for
outdoor use and which conform to one of the
following specifications: Ordinary rubber (60245 IEC
53), Ordinary PVC (60227 IEC 53) or Ordinary PCP
(60245 IEC 57)
• If the cable is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
To start
1. Connect a power cord to the socket below the
handle.
Cross section
2
1.5 mm
2
2.5 mm
115